IMG Home PageIMG ProductsProduct DownloadsOrdering InformationTechnical Support and Frequently Asked QuestionsDeveloper's Corner and UtilitiesAbout IMG
CustomersIMG ResellersMedia InformationIMG Events / Trade ShowsUseful LinksIMG Contact InformationIMG Information / Policies


My-T-Pen Setup

To run My-T-Pen Setup:

Open the Start Menu, Select (All) Programs, Select My-T-Pen, then select the My-T-Pen Setup icon in the My-T-Pen Program Group Menu.

OR

From My-T-Pen, click the My-T-Pen menu button on the tool bar and click My-T-Pen Setup.

OR

From My-T-Pen, open the Main Macro Panel, and click on the button labeled "Setup"

If My-T-Pen is running while you are selecting options from the following setup screens it will change to the new settings immediately after you click OK to save the changes. You do not need to restart My-T-Pen to configure it with the new settings. On each screen you may also choose to click Cancel to exit without saving the new settings.

Once you have created a configuration that you wish to keep, you may wish to save it so My-T-Pen will re-open in the same configuration and screen position. To save a configuration or position, open the My-T-Pen Menu, select Current Settings, and select Save to Save Current Settings (and/or Select Position, Save Current Position). Once saved, My-T-Pen will always open in the saved configuration until another configuration is saved.

In the Operator Mode, My-T-Pen Setup will require a password to allow changes. See Special Handling for information about the Operator Mode.


IMG Home PageIMG ProductsProduct DownloadsOrdering InformationTechnical Support and Frequently Asked QuestionsDeveloper's Corner and UtilitiesAbout IMG
CustomersIMG ResellersMedia InformationIMG Events / Trade ShowsUseful LinksIMG Contact InformationIMG Information / Policies


As seen in ...

Yahoo!finance